Cite This Publication

Robert J. Achatz ORCID logoGoogle Scholar logoScopus logoWeb of Science logo et al.

Abstract: Spectrum reallocations may place broadband radio services (BRS) near spectrum used by 2900–3100 MHz band marine radars. Signals from the BRS base stations can potentially introduce unwanted emissions in the radar detection bandwidth and cause interference. Interference protection criteria (IPC) are needed to mitigate this effect. The primary IPC of concern are the interference to noise power ratio (INR) and the reliability of the radar link at a specified radar signal to noise power ratio (SNR). Reliability is determined by radio wave propagation path loss variability which increases with distance. Distance separation between base stations and radar for various spurious attenuations were calculated using reliability expressions for short radar to target ranges with constant SNR and for longer radar to target ranges with variable SNR. For a magnetron radar under clutter free conditions, 90 dB of spurious attenuation is needed to obtain 90% radar operational reliability at1.2 km when the INR is -6 dB and the SNR is constant. Reducing the INR to -9 and -12 dB increased the separation distance to 1.7 and 2.7 km, respectively. At longer base station to radar separation distances, variable SNR required less spurious attenuation than constant SNR. Consequently, constant SNR analysis can be considered worst case. Distance and frequency separation were calculated using frequency dependent rejection (FDR). These calculations showed that for constant SNR 92.8 MHz of frequency separation is required to meet the 90% reliability IPC at 1.2 km separation distance when the INR is -6 dB. Only 54.6 MHz frequency separation is needed when the separation distance is increased to 32.8 km.

Keywords: radar; interference; radio wave propagation; frequency dependent rejection; interference protection criteria (IPC); spurious emissions; broadband radio service; marine radar; radio spectrum engineering

For technical information concerning this report, contact:

Robert J. Achatz
Institute for Telecommunication Sciences
(303) 497-3498
rachatz@ntia.doc.gov

Disclaimer: Certain commercial equipment, components, and software may be identified in this report to specify adequately the technical aspects of the reported results. In no case does such identification imply recommendation or endorsement by the National Telecommunications and Information Administration, nor does it imply that the equipment or software identified is necessarily the best available for the particular application or uses.

For questions or information on this or any other NTIA scientific publication, contact the ITS Publications Office at ITSinfo@ntia.gov or 303-497-3572.

Back to Search Results